3.Hold the spring retainer clamp and pull the TISS wire assembly to end of reflector at overlap joint. Slide spring retainer clamp over end of reflector as shown.
Step 3
Thimble | Wire & Sleeving |
| Assembly |
End View |
| TISS Wire Assembly | |
Spring | Spring | ||
PN 44176000 | |||
Retainer Clamp |
| ||
|
|
4.After attachment of the TISS, check to make sure that there is sufficient tension on the wire. Follow the diagram below to increase or decrease the tension as necessary.
1.Measure the extension of the spring from the end of the reflector to the thimble as shown below.
11” extension
Thimble | Wire & Sleeving |
| Assembly |
Step 4
Spring |
| If the extension is less than 11” follow the | |
Spring | instruction below to increase the extension. | ||
Retainer Clamp | |||
|
|
Reflector End
2. Tape one end of the sleeve to the burner box or use a marker.
3. Mark the other end of the sleeve with tape or other marker. Use the top of the retainer as a reference.
4. Loosen screws.
5. Pull one end of the sleeve and wire inside until the marker is raised by the total adjusment length. ie. if the extension is 10” then pull through 1” to increase the exension to 11”.
6. Tighten screws.
7. Check extension using the method in step 1.
| Form #43343330 |
May 08 |
