Master fader, Program faders, External effect | GE X-9 specs

2 Getting acquainted with the X-9

Master fader

The master fader is used to control the overall level of the mixed signal output from the X-9.

See “Signal flow” on page 15 for details of how this works in conjunc- tion with the input, etc., signals in the X-9.

Program faders

These faders adjust the levels of the programs after they have been equalized and before they are sent to either the cross-fader or to the master fader.

The fader curve and fader direction can also be set, and fader program start can be carried out.

See “About programs” on page 14 for details of how programs and signals interact.

See “Faders” on page 21 for further details about fader settings.

External effect

These controls affect the assignment and the on/off status of any external effect connected to the X-9.

See “External effects” on page 13 for details of how to connect and use an external effect processor with the X-9.

8 TASCAM X-9Owner’s Manual

Image 8

GE X-9 owner manual Master fader, Program faders, External effect

Contents

Professional Digital DJ Mixer Important Safety Precautions Important Safety Instructions Table of Contents Some notes and precautions IntroductionSerial number, etc Environmental considerations Program gain level, EQ and assignment section Getting acquainted withRoad map to front panel functions Cue selection keys and monitor keys Sampler sectionMicrophone control External effect Master faderProgram faders Cross-fader and fader controls Effect, menu, etc. management Connections Record turntablesCD decks, etc Digital connections Booth outputs Microphone connection and use Headphones connecting and using FootswitchesExternal effects unit Fader start/stop connections External effects To use the external effects unit Learning more About programsCross-fading Assigning sources to programs Signal flow Cue previewing sounds Adjusting the output volumePlaying a song How the X-9 shows characters Menu reference Menus Program EQ Q ValuesMeter release time Meter peak hold Restore factory PresetsMic balance Program 1 balance Faders Program fader curveProgram fader direction Fader start Cross-fader reverse Cross-fader curveCross-fader start Effects Selecting the effect typeEditing the effects Beat parameter Storing effects Effect parametersLPFa Recalling stored effect settings Playing back samples SamplersRecording a sample Sample pitch Editing samplesErasing samples Cutting the EQ bands EQ Q settingViewing EQ settings Remembering and recalling EQ settings Specifications, etc SpecificationsAudio I/O Control I/O Audio specifications General specifications Dimensional drawing Mounting the X-9 in a rack Case mounting Block diagram EtcPage Teac Corporation