Genicom P45 user manual PWR-LED Power/Standby LED, Pwrbt+

English

PWR-LED: Power/Standby LED

When the system’s power is on, this LED will light. When the system is in the S1 (POS - Power On Suspend) or S3 (STR - Suspend To RAM) state, it will blink every second.

Note:

If a system did not boot-up and the Power/Standby LED did not light after it was powered-on, it may indicate that the CPU or memory module was not installed properly. Please make sure they are properly inserted into their corresponding socket.

	Pin	Pin Assignment
HD-LED	3	HDD LED Power
(Primary/Secondary IDE LED)	5	HDD
Reserved	1 4	N. C.
	1 6	N. C.
ATX-SW	8	PWRBT+
(ATX power switch)	1 0	PWRBT-
Reserved	1 8	N. C.
	2 0	N. C.
RESET	7	Ground
(Reset switch)	9	H/W Reset
SPEAKER	1 3	Speaker	Data
(Speaker connector)	1 5	N. C.
	1 7	Ground
	1 9	Speaker	Power
PWR-LED	2	LED Power (+)
(Power/Standby LED)	4	LED Power (+)
	6	LED Power (-) or Standby Signal

E

English

27