SUPER MICRO Computer 6015W-NT Cmos Clear, To Clear Cmos, VGA Enable/Disable, Power Force On

Chapter 5: Advanced Serverboard Setup

CMOS Clear

JBT1 is used to clear CMOS and will also clear any passwords. Instead of pins, this jumper consists of contact pads to prevent accidentally clearing the contents of CMOS.

To Clear CMOS

1.First power down the system and unplug the power cord(s).

2.With the power disconnected, short the CMOS pads with a metal object such as a small screwdriver.

3.Remove the screwdriver (or shorting device).

4.Reconnect the power cord(s) and power on the system.

Note: Do not use the PW_ON connector to clear CMOS.

VGA Enable/Disable

JPG1 allows you to enable or disable		VGA Enable/Disable
		Jumper Settings (JPG1)
the VGA port. The default position
		Jumper Setting Defi nition
is on pins 1 and 2 to enable VGA.		Pins 1-2		Enabled
See the table on the right for jumper		Pins 2-3		Disabled
settings.
Power Force On
Jumper JP1 allows you to enable or
disable the Power Force-On function.		Power Force-On
If enabled, the power will always		Jumper Settings (JP1)
	Jumper Setting		Defi nition
stay on automatically. If disabled (the
	Open		Disabled
default setting), the user must press
	Closed		Force Pwr On
the power button to power on the
system.
LAN Enable/Disable
Change the setting of jumper JPL1 to		LAN Enable/Disable
		Jumper Settings (JPL1)
enable or disable the onboard Ether-
	Jumper Setting		Defi nition
net (RJ45) ports LAN1 and LAN2. See
	Pins 1-2		Enabled
the table on the right for jumper set-
	Pins 2-3		Disabled
tings. The default setting is enabled

5-19