SUPER MICRO Computer 6015W-UR, 6015W-NTR user manual Control Panel, Chassis Front and Rear Views

SUPERSERVER 6015W-UR/6015W-U/6015W-NTR/6015W-NT User's Manual

Figure 6-1. Chassis: Front and Rear Views

Slim DVD-ROM Drive Slim Floppy Drive (optional) System LEDs Control Panel

		SATA Drive Bays		System Reset	Main Power
Power Supply Module	USB Ports		PCI Expansion Slots (w/ riser cards)

Mouse/Keyboard COM1 Port VGA Port Ethernet Ports

Note: the SC815TQ-560U chassis (6015W-U/6015W-NT) has only a single power supply mod-

ule.

6-2 Control Panel

The control panel (located on the front of the chassis) must be connected to the JF1 connector on the serverboard to provide you with system status indications. These wires have been bundled together as a ribbon cable to simplify the connection.

Connect the cable from JF1 on the serverboard to the appropriate header on the Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess cabling out of the airfl ow path.

The control panel LEDs inform you of system status. See "Chapter 3: System In- terface" for details on the LEDs and the control panel buttons. Details on JF1 can be found in "Chapter 5: Advanced Serverboard Setup."

6-2