The WDS Tab
Wireless Distribution System (WDS) technology enables several access points to increase the coverage of a wireless network. Although enterprises or home users can reduce most wiring problems by using access points that support WDS, they still need cables to connect external ISP.
To use WDS, please make sure:
9All routers/AP’s participating in the WDS must use the same RF Channel
9DHCP (if used) must only be enabled on the bridge Router and not on the node AP’s.
Example: Suppose Router1 is connected to the DSL modem, and uses DHCP to dish out IP’s to your WLAN. To use Router1 to bridge to a remote AP, key in AP’s Wireless MAC Address in Router1’s WDS configuration list and select “enable” then press Submit. In AP’s LAN settings, disable DHCP and assure the AP uses the same RF Channel as the Router1. You should now be able to connect to Router1 through AP.
Note that bridging between different vendors wireless gear is not guaranteed. Your
31
