ANTENNANCR CONNECTIONS
ANTENNAS WITH ONE LEAD (Combined VHF-UHF)
VCR
"i _A ®'® _ III
"= lilllllll
:-_-_ !-! nnoooooooIll
75-ohm Comdal(round) Cable To "IN FROM ANT"
300-ohmTwin-lead Flat Cable
ntennaAdaptor (300-ohm to 7S-ohm)(not aupplled)
,.,,,, i.
1.Disconnect the antenna leadsfrom the rear of the
"IV receiver.
2. Identify the type of cable from your antenna. If it is
a round cable as illustrated, it is a 75-ohm coaxial
antenna cable. This cable will connect directly to
the connector marked "IN FROM ANT" on your
VCR.
If your antenna lead wire is a flat type antenna
cable, connect itto the Antenna Adaptor (300-ohm
to 75-ohm) (not supplied) and slip the Adaptor onto
the "IN FROM ANT" terminal. The Adaptor does not
screw onto the VCR, it just slips over the connector.
ANTENNA WITH SEPARATE VHF-UHF LEADS
VHF Antenna UHF Antenna
thmTwin-lead FlatCable
I
i r rr iii ii -I__
VCR
To "IN FROM ANT"
Antenna Mlxer (VHF/UHF 300-ohm to
75-ohm) (not supplied)
1.Disconnect the UHFNHF twin leads on your tele-
vision.
2. Locate Antenna Mixer(VHF/UHF 300-ohm to 75-
ohm) (not supplied).
3. Connect the VHF Twin-lead Cable to the "VHF"
terminals on the Antenna Mixer.
4. Connect the UHF Twin-lead Cable to the "UHF"
terminals on the Antenna Mixer.
5. Slip the Antenna Mixer onto the "IN FROM ANT"
terminal.
-6-