REMOTE CONTROL
The remote control is used for most of the operations and features of the VCR. Before proceeding, install
batteries into the remote and getfamiliar with the buttons on the remote.
SIGNAL TRANSMISSION WINDOW
Transmits an invisible light beam from the Remote
Control to the VCR.
"POWER" ON/OFF BUTTON
Press to turn VCR on. Press again toturn VCR off.
Aim the remote control at the receiver on the front
panel of the VCR.
NOTES:
1. Ifthe range isshort, try new batteries.
2. An object between the VCR and remote control
may block the invisible light beam and operation
TRACKING/CHANNEL SELECT BUTTONS
•"AUTO" TRACKING: When playback is started,
the auto tracking function operates and adjusts
tracking automatically so the picture isoptimized.
"AUTO TRK" flashes on the TV screen for
several seconds.
•MANUAL "TRACKING"/"CHANNEL" SELECT
("V" and "A ") BUTTONS
"TRACKING": If noise appears on the screen
during playback, press "V" or "&" button until the
noise on the screen is reduced or eliminated.
"CHANNEL": You can scan up or down through
all the memorized channels using the Channel
Select button (V or A).
NOTES:
• Tracking is automatically reset to normal when a
tape is inserted or the power cord is unplugged.
• Auto tracking may not operate correctly when the
tape is scratched or the recorded condition is
poor.
In this case, press the TRACKING control button
(V or A) to adjust tracking.
•If the AUTO TRACKING button is pressed after
operating the TRACKING control button (V or
A), auto tracking operates again.
NORMAL OPERATION BUTTONS
These buttons (except for "STOP" button) function
same as the buttons on the front of your VCR.
• "STOP" BUTTON
If this button is pressed while the set is operating,
the running of tape stops and all operating modes
are cancelled.
POWER TUiAV TVNCR
CHANNEL/
TRACKING
PLAY
MENU CLEAR DISPLAY
@®@
®®®@®®
@ P,',-nEP
CLOCK/
VISS COUNT RESET
© © ©
REMOTE CONTROL
J
-18-