Test Run
Before starting the resaw, make sure you have performed the preceding assembly and adjustment instructions, and you have read through the rest of the manual and are familiar with the various functions and safety issues associated with this machine. Failure to follow this warning could result in serious personal injury or even death!
To test run the resaw:
1.Make sure the wheel cover and electrical box is closed and all tools or other objects are cleared away from the machine.
2.Put on safety glasses and make sure any bystanders are out of the way and also wear- ing safety glasses.
3.Tension the blade.
4.Turn ON the master switch that is located on the outside of the electrical box.
5.Turn the POWER ON switch (shown in Figure 21) clockwise.
Figure 21. POWER ON switch.
6.Press the UP and DOWN buttons to make sure the resaw head moves in the proper direction.
—If the resaw head moves in the opposite direction as indicated, then the machine has been wired out of phase. To cor- rect this, disconnect the power to the machine, open the electrical box, and switch any two current carrying wires (R, S, or T) that connect the machine to the power source.
7.Push the emergency stop button in, then twist it clockwise until it pops out.
8.Once you have performed Steps
9.Press the conveyor lever forward to test the conveyor belt.
—If any problems occur, press the EMG STOP button. Investigate and cor- rect the problem before operating the machine further. If you need help, refer to the troubleshooting section in the back of this manual.
—If you cannot easily locate the source of an unusual noise or vibration by yourself, please contact our service department at (570)
G0504 16" Horizontal Resaw Bandsaw |
