Grizzly G0504 owner manual To clean the tank screen, To clean the bottom of the tank

3.Replace the drain plug after the hydraulic tank is completely drained.

To clean the tank screen:

1.Remove the access plate on top of the hydraulic tank as shown in Figure 33.

Tank Screen

Located

Inside Tank

Figure 33. Access plate removed from tank.

2.Remove the tank screen, clean it with solvent and compressed air, and allow it to dry. (Re- install the tank screen AFTER you clean the

bottom of the tank.)

To clean the bottom of the tank:

1.Use a lint free rag to wipe up and remove any sludge from the bottom of the tank.

2.Use clean hydraulic fluid on a clean rag to wipe up additional contaminants from the bot- tom and sides of the tank.

3.Replace the tank screen and access plate.

To fill the tank with new fluid:

1.Make sure that you have re-installed the tank screen, that the drain plug is tight, and that you have replaced the access plate on top of the tank.

2.Using an ISO VG 10—Antiwear 10 Hydraulic Fluid, fill the tank until the sight window is 2⁄3 full between the hi and low marks on the sight window. Note—This will take approximately 13.5 gallons.

-34- G0504 16" Horizontal Resaw Bandsaw