Grizzly G0504 owner manual Setting Memory Using Memory Button, To set the memory function

Setting Memory	Using Memory
Button	Preset Keys

The blade memory button lowers the blade a pre- determined distance each time it is pressed. This allows you to make a series of cuts from the top side of the workpiece, all of the same thickness.

Be sure to add the blade kerf to the desired thickness of the cut-off pieces when setting the memory function. For example, if you want your cut-off pieces to be 1" thick and the kerf of the blade is 0.06", the memory function needs to be set to 1.06".

The blade memory function is also used when you want to make resaw cuts thinner than 1⁄4". Because the blade cannot be adjusted closer than 1⁄4" to the table, resaw cuts thinner than 1⁄4" need to be cut from the top side of the workpiece.

To set the memory function:

1.Turn the control panel POWER ON switch clockwise to supply power to the control panel.

2.Press the FUNC key.

3.Enter the distance, to the nearest hun- dredth's place, that you want the blade to lower. For example, if you want the blade to lower 2.06", press 2, 0, 6 on the key pad. If you want the blade to lower 0.56", press 5, 6.

4.Press and hold the SET key for approxi- mately 5 seconds or until the display stops flashing.

5.Press the MEMORY button and the blade will automatically lower the distance set into the memory function.

Note—For best results,make a few cuts while using the MEMORY button, measure the workpiece, and adjust the memory setting according to the measurements of the cut-off workpiece.

The memory preset keys (A, B, C, D) allow four dimension sizes to be saved and recalled.

For example, if you have 500 pieces to resaw and the starting size is 2" thick on all of them, then you can save 2" in one of the memory keys. After cutting down each piece, press that memory pre- set key to return to the starting height of 2" for the next whole piece.

To store a height in the A memory preset key:

1.Press the A key. The current preset height flashes on the display.

2.Enter the height you wish to store. For exam- ple if you want to store 2" as the height", press 2, 0, 0 on the key pad.

3.Press and hold the A key for 3 seconds. The display zeros out and stops flashing.

To use the stored memory preset in the A key:

1.Press the A key. The current preset height flashes on the display.

2.Press the START key on the key pad. The blade moves to the stored height dimen- sion.

Note—To stop a stored memory preset from moving to its stored height, press the STOP key on the key pad AFTER you have pressed the memory preset key (A in this example).

-26- G0504 16" Horizontal Resaw Bandsaw