5.On the side that the belt tracks away from, turn the front adjustment nut clockwise half of a turn, and watch the belt tracking.
—If the tracking was not corrected by this adjustment, repeat Step 4.
6.When the conveyor belt is tracking in the center of the roller brackets, run the con- veyor for at least two minutes to ensure that it will remain tracking correctly.
7.Tighten the rear adjustment nuts against the bracket plates, then tighten the front adjust- ment nuts against the bracket plates to make sure that the tracking adjustment will not slowly change during normal operation.
Replacing Conveyors
Although the conveyor belts have slight differenc- es in size and access, the replacement instruc- tions are the same.
To replace the conveyor belts:
1.Start the conveyor belt that you want to replace.
2.Stop the conveyor belt when the conveyor belt seam (see Figure 41) is accessible.
Figure 41. Conveyor belt seam.
G0504 16" Horizontal Resaw Bandsaw |
