Grizzly G0504 owner manual Main motor 440V wiring

3.Remove the wiring box covers on the main motor and elevation motor.

4.Wire the main motor and elevation motor as shown on the diagrams on the inside of each motor wiring box cover. (The circled refer- ences on the diagrams represent labels on the wires.)

Note: Figures 5 & 6 below have been pro- vided for your reference and are current at the time that this manual was written. However, always use the diagram on the wire cover that comes with your motor! Also, the electrical system on this machine is setup for the "RUN" diagrams shown on the wire cover. Ignore the "START" diagrams for this machine.

���������

�� �� ��

�� �� ��

�� �� ��

�� �� ��

5.Replace the main motor relay (LR3D-3359 48/65A) with the relay from kit (LR3D-3355 30/40A) and set the dial to “33.”

6.Replace any wire duct covers and motor wir- ing box covers you might have removed dur- ing this procedure, and close the electrical box door.

To avoid electrocution or fire, ensure all wiring mod- ifications are inspected and approved by a quali- fied electrician before con- necting the machine to the power source.

Figure 5. Main motor 440V wiring.

���������

�� �� ��

�� �� ��

�� �� ��

�� �� ��

Figure 6. Elevation motor 440V wiring.

G0504 16" Horizontal Resaw Bandsaw -11-