Test Run
Inspect your machine for loose nuts and bolts, and ensure no tools are left in or around the machine
before reconnecting power.
Now that the lathe is securely in place and you’ve read the safety guidelines, it’s time to give the machine a test run.
Before starting the machine:
1.Make sure the machine is properly ground- ed, the power switch is in the “OFF” position and the reversing switch is selected for for- ward.
2.Inspect the machine to ensure that all hand tools are out of the way, guards are in place and nothing is impeding the movement of the chuck. Check this by rotating the chuck by hand.
3.Rotate the System Reset Button and allow it to pop out. Push the start button on the con- trol panel while keeping a finger poised over the stop button. The machine should run smoothly with little or no vibration or rubbing noises when it starts. Strange or unnatural noises should be investigated and corrected before operating the machine further.
If the direction is reversed, contact our service department for further instructions.
4.If the lathe/mill is running correctly, push the stop button, wait for the machine to come to a complete stop and take some time to review the various controls.
Keep clothing rolled up and out of the way of machinery and keep hair pulled back.
Disconnect power to the machine when perform- ing any adjustments or maintenance. Failure to do this may result in seri- ous personal injury.
Wear safety glasses dur- ing all operations on the shaper. Failure to com- ply may result in serious personal injury.
G4015Z Lathe/Mill |
