GSI Outdoors PNEG-951

This Equipment shall be installed in accordance

with the current installation codes and applicable

regulations which should be carefully followed in

all cases. Authorities having jurisdiction should be

consulted before installation occurs.

Printed in the USA

The GSI Group, Inc.

1004 E. Illinois St.

Assumption, IL 62510-0020

Phone: 217-226-4421

Fax: 217-226-4420

e-mail: gsisales@grainsystems.com

internet: http://www.grainsystems.com

Contents

Main Page Table of Contents Section 3Contol Panel....................................................................17 Section 4Dryer Pre Season Checks...........................................29 Section 5Dryer Startup and Operation......................................35 Section 6Safety Circuit Shutdown Messages............................49 Section 9Drying Charts...................................................................77 Section 10Technical Reference.........................................................85 2 & 3 Module Network Dryer Manual History Introduction GSI Network Portable Dryers Page THE GSI GROUP, INC. WARRANTY Page WARNING! BE ALERT! SAFETY ALERT SYMBOL DRYER OPERATION EMERGENCY STOP Decal: DC-1317 Decal: DC-1224 Decal: DC-889 Decal: DC-972 Decal: DC-971 Decal: DC-974 Page Page READ THESE INSTRUCTIONS BEFORE OPERATION AND SERVICE SAVE FOR FUTURE REFERENCE USE CAUTION IN THE OPERATION OF THIS EQUIPMENT Page Page SWITCH PANEL LAYOUT CONTROL POWER SWITCH DRYING MODE SWITCH LOAD AUGER SWITCH FAN SWITCH HEATER SWITCH UNLOAD SWITCH KEYPAD LAYOUT SETUP BUTTON DELAY BUTTON SCREENS BUTTON Out of Grain Time Page Page User Hour Meter Page Page Page Page Page LOAD AUGER UNLOAD ONE SPEED OPERATION UNLOAD TWO SPEED OPERATION METERING ROLL OPERATION Meter Roll 1 Speed Display FAN SWITCHES BURNER SAFETY BURNER TEST FIRE Page Page Page FULL HEAT DRYING DRYING TEMPERATURES Fan and Auger Delays Dryer Shutdown INITIAL SETUP PARAMETERS Timer and Delay Settings Page Page Page Setting Up The Temperature Set Points STARTUP Startup Procedure CONTINUOUS FLOW DRYING MODE Full Heat-Continuous Flow Operation Dry and Cool-Continuous Flow Operation STAGED BATCH DRYING MODE Continuous-Batch Operation Page OPERATING DISPLAY SCREENS Main Display Screen Page Page FAN AND HEATER GENERATED ERRORS 51PNEG-951 Page Vapor x High Limit INPUT/OUTPUT GENERATED ERRORS Air System Failure Aux Load Overload Aux Unload Overload Page MASTER DISPLAY GENERATED ERRORS Page Page Before starting any repairs or maintenance on your dryer, observe the following safety steps: SEASONAL INSPECTION AND SERVICE LUBRICATION PROCEDURE SUGGESTED LUBRICANTs AND SCHEDULES* Page Page FAN MOTOR REMOVAL HEATER PARTS REMOVAL AND INSTALLATION METER ROLL SERVICING MAIN CONTROLS HOW TO CLEAR A JAMMED METERING ROLL TROUBLE ANALYSIS PROCEDURE Page Page Page Page Page METER ROLL DISABLE AIR SWITCH TESTING METER ROLL REVERSE Reverse time Forward time SELECT UNLOAD METHOD SELECT DRYER ADDRESS ATTEMPT TO REFILL MODEL NUMBER Page IMPORTANT NOTE! It is possible to change all your fan and heaters to an inactive state which would SET TIME & DATE Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page NOTES