Hearth and Home Technologies SL-550TRSI-AUE manual Finishing, Ceiling

1.6 FINISHING

The minimum clearance to combustibles are 0 from the sides, floor, back and top (these clearances are defined by the standoffs). The minimum distance to the perpendicular side wall extending past the appliance front is 2-inches (51mm). Clearance to a mantelpiece is shown in Figure 33.

IF JOINTS BETWEEN THE FINISHED WALLS AND THE FIREPLACE SURROUND (TOP AND SIDES) ARE SEALED, A 300° F (149°C). MINIMUM SEAL-

ANT MATERIAL MUST BE USED. THESE JOINTS ARE NOT REQUIRED TO BE SEALED. ONLY NON- COMBUSTIBLE MATERIAL (USING 300° F. (149°C)

MINIMUM ADHESIVE, IF NEEDED) CAN BE AP- PLIED AS FACING TO THE FIREPLACE SUR- ROUND. SEE FIGURE 33.

							CEILING
							31”
				12” (305mm)			(787mm)
				11” (279mm)
			10” (254mm)
		9” (229mm)
	8” (203mm)
	7” (178mm)						9”
6” (152mm)						(229mm)
5” (127mm)							10”
					6”
4” (102mm)							(254mm)
				(152mm)
3” (76mm)						7”	11”
2” (51mm)				5”	(178mm)		(279mm)
			4”	(127mm)		8”	12”
2”	3”		(102mm)			(203mm)	(305mm)
	(76mm)
(51mm)
	TOP FRONT EDGE
	OF FIREPLACE
	NON-COMBUSTIBLE						FINISH MATERIAL
		BOARD					MAY BE COMBUSTIBLE
							- TOP AND SIDES
			TOP SEAL				OF UNIT
			JOINT
			SIDE SEAL
			JOINT
							0”
					1/2”
					(13mm)
Figure 33.
Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. B • 7/06								25