Hearth and Home Technologies SL-550TRSI-AUE Installing Flue Components, Flueing Out the Rear Flue

Installing Flue Components

After determining which set of starting collars will be used (top or rear), follow flueing instructions accordingly.

Flueing Out the Rear Flue

Remove the rear collar seal cap by cutting the strap at each end (see Figure 17).

Next, remove the insulation from the rear flue, pull the heat shield out from outside of the heater.

! WARNING: THE TOP FLUE COLLAR SEAL CAP MUST REMAIN ATTACHED TO THE TOP FLUE COLLAR IF THE FLUE

SYSTEM IS ATTACHED TO THE REAR STARTING COLLARS. SEE FIGURE 17.

Flueing Out the Top Flue

Remove the top collar cover plate. Remove the seal cap and both pieces of insulation in the top collars (see Figure 17). Remove the heat shield inside the top collars from the outside of the heater.

!WARNING: THE REAR FLUE COL- LAR SEAL CAP MUST REMAIN AT- TACHED TO THE REAR FLUE COL- LARS IF THE FLUE SYSTEM IS AT- TACHED TO THE TOP STARTING COLLARS. SEE FIGURE 17.

!WARNING: FAILURE TO REMOVE INSULATION IN THE SET OF COL- LARS YOU ARE USING COULD CAUSE A FIRE.

!WARNING: YOU MUST LEAVE THE INSULATION IN PLACE IN THE SET OF COLLARS YOU ARE NOT USING.

Insert screwdriver	FLUEING OUT REAR		FLUEING OUT TOP
or similar object		SEAL
here to remove cap.	SEAL		INSULATION,
		CAP
	CAP		DISCARD
			BOTH
			PIECES and
			HEAT SHIELD

HEAT

SHIELD

HEAT

DISCARDSHIELD

INSULATION

and

HEAT SHIELD

CUT

HERE

Figure 17.

Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. B • 7/06 17