Installing Flue Components
A. On the REAR of the heater
1.Attaching the First Flue Component to the Start- ing Collars:
To attach the first flue component to the starting collars on the rear of the heater:
•Make sure that the flue gasket supplied with the heater seals between the first flue component and the outer heater wrap.
•Slide the male end of the inner flue of the pipe sec- tion over the inner collar on the heater. At the same time, slide the outer flue over the outer collar on the heater. Push the flue section into the appliance col- lar until all the lances (see Figure 18) have snapped in place. Tug slightly on the flue to confirm that it has completely locked into place.
Figure 18.
• Any 90° elbow installed directly on the back of a rear flueing heater MUST BE in a vertical position.
! WARNING: ENSURE THAT THE HEATER GASKET SUPPLIED WITH THE HEATER SEALS BETWEEN THE FIRST FLUE COMPO-
NENT AND THE OUTER HEATER WRAP.
WARNING
Fire Risk
Exhaust Fumes Risk
Impaired Performance of Appliance
• Overlap pipe slip sections at least
38 mm.
• Screws must not exceed one inch long.
• Pipe may separate if not properly joined.
2. Assembling Flue Components
Insert the inner flue of section A into the flared inner flue of section B.
Start the outer flue of section A over the outer flue of section B (see Figure 19). Note: The end of the pipe sections with the lances/tabs on it will face towards the appliance.
Once both inner and outer flues are started, press sec- tion A onto section B firmly until all lances have snapped into place. Check to make sure they have snapped together (see Figure 20) and the seams are not aligned (see Figure 21). Tug slightly on section A to confirm it has completely locked into place.
A
B
Figure 19. | Figure 20. |
18 | Heat & Glo • |
