10 Electrical Information
A. Recommendation for Wire
This appliance requires
Open the control access panel to view wiring system and gas valve. If this appliance has a red or black ignitor button (as noted in Figure 10.1) this appliance has a standing pilot ignition system. If there is no red or black ignitor button, this appliance has an Intellifi re ignition system.
Figure 10.1 Ignitor Button
Note: This appliance must be elecrtrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/NFPA
B. Connecting to the Appliance
WARNING
Shock Risk
Explosion Risk
Do NOT wire 110V to valve.
Do NOT wire 110V to wall switch
•Incorrect wiring will damage millivolt values.
•Incorrect wiring will override IPI safety lockout and may cause explosion.
•This appliance may be used with a wall switch, wall mounted thermostat and/or a remote control.
•If using thermostat use one compatible with a millivolt gas valve system.
•Follow parameters for locating thermostat (see individual thermostat instructions) to ensure proper operation of appliance.
•Use low resistance thermostat wire for wiring from ignition system to the wall switch and thermostat.
•Keep wire lengths short as possible by removing any excess wire length.
•Low voltage and 110 VAC voltage cannot be shared within the same wall box.
C. Intellifire Ignition System Wiring
This appliance requires a 110 VAC supply to the appliance junction box for operation. A wiring diagram is shown in Fig- ure 10.2.
This appliance is equipped with an Intellifi re control valve which operates on a 3 volt system.
This appliance is supplied with a battery pack and a 3 volt AC transformer, which requires the installation of the sup- plied junction box. It is highly recommended that the junction box be installed at this time to avoid reconstruction.
The battery pack requires two D cell batteries (not included). Batteries cannot be placed in the battery pack while using the 3 volt AC transformer. Conversely, the transformer must be unplugged if the battery pack is used.
CAUTION
Battery polarity must be correct or module damage will occur.
Optional Accessories Requirements
Wiring for optional accessories should be done now to avoid reconstruction.
CAUTION
Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.
CAUTION
Shock Risk
•Replace damaged wire with type 105° C rated wire.
•Wire must have high temperature insulation.
Heatilator • GB4336/GB4992 • | 21 |
