FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.
This appliance must be installed in accordance with local codes, if any; if not, follow ANSI Z223.1 or, in Canada, current
Standing Pilot Ignition
Heatilator •
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn knob. Never use tools. If the manual gas valve will not push in or turn by hand, don't try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
This appliance must be properly connected to a venting system in accordance with the manufacturer's installation instructions.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner's information manual provided with the appliance. For assistance or additional information consult a qualified installer, service agency or the gas supplier.
GB4336/GB4992
LIGHTING INSTRUCTIONS
Stop! Read the safety information above on this label.
CAUTION: Hot while in operation. Do not touch.
•
1.Turn wall switch to the "OFF" position or thermostat to the lowest setting.
2.Remove control access panel.
3.Turn manual gas valve to CLOSED. Wait five [5] minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information above on this label. If you don't smell gas, go to next step.
4.Turn gas line to "OPEN".
5.Turn pilot knob clockwise 
to "OFF". (Knob may have to be depressed to pass "PILOT" position.)
6.Locate pilot assembly inside appliance.
7.Locate red ignitor button.
8.Turn pilot knob to "PILOT" and push in.
9.Continue to hold in pilot knob and push the red ignitor button
10.Continue to hold in pilot knob for approximately one minute. Pilot should remain lit. If pilot goes out, wait 5 minutes and repeat Steps
11.Release and turn knob counterclockwise 
to "ON".
12.If appliance will not operate, follow the instructions "TO TURN OFF GAS TO APPLIANCE" and call your service technician or gas supplier.
3. CLOSED
7
4. OPEN
5
OFF | VENT |
ON |
|
Keep children, clothing, furniture, gasoline and other liquids having flammable vapors away.
WARNING RISK OF FIRE
This appliance is intended to burn a specified gas fuel only. Do not attempt to use with solid wood fuel or another type of fuel. Do not attempt to modify or use any other type of gas burner system.
WARNING: Disconnect the electric power before servicing. If for any reason the original wire supplied with the appliance must be replaced, it must be replaced with 105° C or its equivalent.
For use with natural gas or propane. A conversion kit as supplied by the manufacturer shall be used to convert this appliance to the alternative fuel.
* Also certified for installation in a bedroom or a |
NOTE: To light main burner, turn wall switch to "ON". Do not light by hand.
OT PIL5
ON OFF
ON
OFF
PILOT
OFF ON
PILOT
* For U.S. only! |
31
TO TURN OFF GAS TO APPLIANCE
1. | Turn off wall switch or set thermostat to lowest setting. | 3. | Turn manual gas valve to "CLOSED position. Do not force. |
2. | Remove control access panel. | 4. | Replace control access panel. |
Due to high surface termperatures, keep children, clothing and furniture away. |
|
Keep burner and control compartment clean. See installation and operating instructions accompanying the appliance. | 29097D |
|
