C. Tools and Supplies Needed
Before beginning the installation be sure that the following tools and building supplies are available.
Reciprocating saw | Framing material |
Pliers | Hi temp caulking material |
Hammer | Gloves |
Phillips screwdriver | Framing square |
Flat blade screwdriver | Electric drill and bits (1/4 in.) |
Plumb line | Safety glasses |
Level | Manometer |
Voltmeter | Tape measure |
1/2 - 3/4 in. length, #6 or #8
D. Inspect the Appliance and Components
WARNING
Inspect appliance and components for damage. Damaged parts may impair safe operation.
•Do NOT install damaged components.
•Do NOT install incomplete components.
•Do NOT install substitute components.
Report damaged parts to dealer.
The following
•Appliance
•Pipe components
•Firestops
•Attic insulation shield
•Elbows
•Strapping
•Roof fl ashing or chase top
•Termination cap
•Storm Collar
•Carefully remove the appliance and components from the packaging.
•The vent system components and trim doors are shipped in separate packages.
•The gas logs may be packaged separately and must be fi eld installed.
•Report to your dealer any parts damaged in shipment, particularly the condition of the glass.
•Read all of the instructions before starting the installation. Follow these instructions carefully during the installation to ensure maximum safety and benefit.
Vertical
Termination
Cap
Storm
Collar
Roof
Flashing
Ceiling
Firestop
Sections
Figure 2.2 Typical Vertical Installation
WARNING
Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:
•Installation and use of any damaged appliance or vent system component.
•Modifi cation of the appliance or vent system.
•Installation other than as instructed by Hearth & Home Technologies.
•Improper positioning of the gas logs or the glass door.
•Installation and/or use of any component part not approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
Heatilator • GB4336/GB4992 • | 7 |
