English
INSTALLING A FITTING
Before using the model NT50AGF Pneumatic Flooring Nailer, a 3/8” Thread Fitting must be installed. The NT50AGF Pneumatic Flooring Nailer has an adapter installed to accept a 3/8” Thread fitting. This provides the owner the advantage of installing the preferred Fitting of choice. (ie: Hitachi Fittings; Industrial (P/N 190051), Automotive (P/N 190071)). This allows the freedom to use any configuration of quick connect fitting with either a 3/8 NPT thread or a combination of a 1/4 NPT thread fitting and 3/8 – 1/4 NPT reducer. Install the Fit- ting into the supplied adapter and gently tighten.
CAUTION: Do not remove the installed adapter. This adaptor pro- vides connection of the Fitting of choice as well as protecting the integrity of the NT50AGF Pneumatic Flooring Nailer Body from inlet port damage.
IMPORTANT: The bottom hole of the NT50AGF that is plugged should NEVER be removed. If plug is removed, the NT50AGF Pneu- matic Flooring Nailer will not perform cor- rectly and serious damage may occur.
CHANGING FLOORING SHOES
Loosen or remove Flange Nuts (Ref. No. 33) with Wrench and unscrew the Shoe Screw (Ref. No. 50) to remove and change over from Tongue Nailing to Face Nailing Applications. Change from Face Nailing to Tongue Nailing by loosening or removing Flange Nuts (Ref. No. 33) with Wrench and Face Shoe Screw (Ref. No. 42). Always tighten the Shoe Screw (Ref. No. 50 or 42) before tightening the Flange Nuts (Ref. No. 33).
33
50
33
42
