LOADING ACCESSORIES INTO THE OVEN
If you are loading an HR5, skip steps
1. | Turn Main Power dial to . |
|
2. | Turn Rotisserie dial to | to rotate rotor. |
3.Turn Rotisserie dial to "0/P" to stop rotation when the hole pattern (Fig. 17) is located at the bottom of the oven.
4.Verify that the hole pattern is identical to the top illustrated hole pattern shown in Fig. 17.
5.If hole pattern does not match the top illustrated hole pattern, but does match the bottom illustrated hole pattern in Fig. 17:
a.Take rotor assembly out of oven.
b.Flip rotor assembly.
c.Place rotor assembly back in oven.
d.Repeat steps
HR7
Fig. 17
6.Load accessory with product into oven. Make sure the product is distributed evenly. (See the next page for further instructions on loading specific accessories into the oven.)
7. Turn Rotisserie dial to | to rotate rotor. |
8.Turn Rotisserie dial to "0/P" to stop rotation.
9.Load accessory with product into the oven.
10.Repeat steps
11.Close oven door.
When you load any accessories with a product into the oven, make sure the product clears the top of the oven and no part of the product is sticking out.
Do not mix accessories on the rotor.
– 27 –