Hobart HR5 manual Assembling the Rotor HR7 only

Assembling the Rotor (HR7 only)

You should have: (2) rotor end plates; (1) rotor shaft; (12) screws

1.Face the two rotor end plates against each other to make sure the holes match. This is done to ensure you have a matched set of rotor end plates. If holes do not match, the accessories will not align properly.

2.Align the holes on the left rotor end plate (as you face the rotor) with the holes on one side of the rotor shaft.

3.Secure the rotor end plate to the rotor shaft with the screws available (Fig. 2).

LEFT HAND

ROTOR END PLATE

ROTOR SHAFT

HR7

Fig. 2

4. Assemble the right rotor end plate (as you face the rotor).

PL-53376

5.Align the hole pattern with the assembled left rotor end plate as indicated by the dotted lines shown below (Fig. 3). This is done to ensure the rotor end plate is in the correct position.

6.Repeat steps 2 and 3 to secure the right rotor end plate.

LEFT HAND

ROTOR END PLATE

ROTOR SHAFT

RIGHT HAND ROTOR END PLATE

HR7

Fig. 3

PL-53377

– 8 –