Manuals / Hobart / Kitchen Appliance / Oven

Hobart HR5 Loading Racks, Baskets, or Baking Plate Into Oven, Unloading Accessories From Oven

Models: HR5

1 36

Download 36 pages 25.73 Kb

Page 29

Image 29

Loading Racks, Baskets, or Baking Plate Into Oven

A Chicken Rack, Basket, and Baking Plate all load the same. Loading a basket is shown (Fig. 20).

1.Place one end of the accessory into the a rotor end plate.

2.Place the other end of the accessory into the corresponding hole on the other rotor end plate. Make sure the accessory is level.

BASKET

HR7

Fig. 20

PL-53380

UNLOADING ACCESSORIES FROM OVEN

Opening the door does not stop the rotisserie or cooking process.

1.Press STOP/START. Red light on button will go off.

2.Turn Thermostat dial to 0°F.

3. Turn Main Power dial to .

4.Turn Rotisserie to "0/P" to stop rotation.

5.Remove an accessory with insulated gloves or safety mitts.

6.Turn Rotisserie dial to to rotate.

7.Turn Rotisserie to "0/P" to stop rotation.

8.Repeat steps 5 thru 7 until unloading is complete.

– 29 –

Page 29

Image 29

Hobart HR5 manual Loading Racks, Baskets, or Baking Plate Into Oven, Unloading Accessories From Oven

Contents

HW5 & HW7 WARMERS T I OHR5 & HR7 ROTISSERIE OVENS HOBART CORPORATION TABLE OF CONTENTSSetting the Roasting Time Setting the TemperatureSetting an Early Warning Buzzer Setting End Time Delayed StartModel HR7 Oven Model HR5 OvenModel HW5 Warmer Model HW7 WarmerFeatures and Options Installation, Operation and Care of HR SERIES ROTISSERIE OVENS ANDHW SERIES ROTISSERIE WARMERS GENERALWARMERS OVENSASSEMBLY INSTALLATIONLOCATION LEGS / CASTERSAssembling the Rotor HR7 only 7. Place the assembled rotor in the oven Single Oven or Warmer ELECTRICAL CONNECTIONSStacked Ovens or Oven and Warmer PHASE ELECTRICAL DATAMODEL VOLTSBEFORE FIRST USE OPERATIONDisplay PROGRAMMABLE OVEN CONTROL PANEL WITH MANUAL CONTROLS FigProgrammable Controls Manual ControlsUsing Manual Controls Main Power DialMANUAL CONTROLS Fig Thermostat DialPROGRAMMABLE CONTROLS Fig Setting the Time of DayProgramming Menu Buttons Verifying Programmed Temperatures and TimesChanging a Programmed Setting Displaying Time/Temperature During a Processing CycleStarting a Processing Cycle Interrupting a Processing CycleSetting an Early Warning Buzzer Setting the End Time Delayed StartTurning the Buzzer Off Stopping the RotisserieAutomatic Controls AUTOMATIC OVEN CONTROL PANEL WITH MANUAL CONTROLS Fig DisplayMAIN POWER DIAL PL-53361 Manual ControlsUsing Manual Controls Main Power DialMANUAL CONTROLS Fig Thermostat DialSetting the Roasting Time Setting the TemperatureAUTOMATIC CONTROLS Fig DISPLAY TEMPSetting an Early Warning Buzzer Setting End Time Delayed StartInterrupting an Automatic Cooking Operation Resetting the Automatic Control Changing A SettingStopping an Automatic Cooking Operation Turning the Buzzer OFFPREPARING THE PRODUCT LOADING PRODUCTS ONTO ACCESSORIESLoading Products onto Spits V Spit StandardLoading Products onto Chicken Racks Optional Fork Spit OptionalTurkey Spit Optional Load the chickens, breast up, in the basket Fig. 15 Loading Products in a Basket OptionalPL-41369-1 PL-41370-1LOADING ACCESSORIES INTO THE OVEN Loading Fork Spits Into Oven Loading Spits Into OvenPL-53379 PL-53378Loading Racks, Baskets, or Baking Plate Into Oven UNLOADING ACCESSORIES FROM OVENTemperature SUGGESTED ROASTING GUIDELINESInternal CapacityEmpty the grease drawer when necessary Be careful if grease is warm EMPTYING GREASE DRAWER3. Close drain valve when empty Fig 4. Slide grease drawer shut 1. Open door and slide grease drawer out about 5 13 cm FigWARMER CONTROLS Fig USING WARMERS Models HW5 and HW7CLEANING STAINLESS STEEL SURFACES CLEANINGCLEANING NONSTICK COATED SURFACES Do Not go longer than eight hours without cleaningCAUTION Cleaning should not be delayed beyond 8 hours of service How To Clean Nonstick Coated Surfaces Routine CleaningHow To Clean Severe Buildup on Nonstick Coated Surfaces CLEANING PROBECLEANING WARMERS CLEANING GREASE DRAWERCLEANING QUARTZ LAMPS MONTHLY CLEANINGMODEL HR5 OVEN ONLY MAINTENANCESERVICE