Holder A6 VM 55 EP Maintenance Every 1000 Service Hours, Checking V-belt Tension and Condition

Operating Instructions

Maintenance Every 1000 Service Hours

C 9700 ... C 9.88 H

Checking V-belt Tension and Condition

See the operating manual of the engine manufacturer.

CAUTION

Adjust V-belt tension only when the engine is shut off.

-Inspect V-belts for cracks and tears over their entire length.

-Replace damaged V-belts.

-Using thumb pressure, check if the V-belt can not be depressed more than 10 - 15 mm.

-To tighten the V-belt: Loosen the idler pulley mounting screws and push the pulley outwards until the proper V-belt tension is reached.

-Tighten the idler pulley mounting fastening screws.

Changing the Fuel Filter

See the operating manual of the engine manufacturer.

-Remove the fuel filter cartridge with a filter wrench.

ATTENTION

Observe the instructions for handling fuels and lubricants.

-Clean the mating surface of the filter mount.

-Coat the new seal with oil.

-Install and hand tighten the new filter cartridge with a new seal in the filter mount.

NOTE

The fuel system bleeding takes place auto- matically.

Cleaning/Replacing the Fuel Pump Strainer

See the operating manual of the engine manufacturer.

184 145 052