Holder C 9.83 H, VG 50 EP Adjusting Catch Hook and Catch Hook Bar, C 9700 ... C 9.88 H, Danger

Operating Instructions

Operating the Implements

C 9700 ... C 9.88 H

Adjusting Catch Hook and Catch Hook Bar

You can adjust the catch hook laterally and longitudinally.

-Measure the stand-off of the pins on your implement.

-Disengage the clamping screws (6) on both sides.

-Slide the catch hook laterally until the required distance is reached.

-Retighten the clamping screws.

-Equipment of category II can be attached with the catch hook (5) directly;

-For equipment of category I install the reducing sleeves on the left and right.

Adjusting the Length of the Catch Hook Bar

-Disengage 2 locknuts and clamping screws (inside and at bottom) on the lower link (2).

-Pull the linch pin out of the pin (1) and remove the pin.

-You can put the catch hook bar (3) in one of 3 positions.

-Insert the pin (1) in the hole and secure with the linch pin.

-Retighten the locknuts and clamping screws.

DANGER

Make sure no-one is standing between the tractor and implement.

-Drive the tractor to the implement to be picked up.

2 3 4

1

Bild_53		6	5
1	Pin with linch pin		4 Quick attach
2	Lower link support		5 Catch hook
3	Catch hook bar		6 Clamping screw

(adjustable) with 3 positions

Hole	Position	Used for
1st hole	Front	Category I and II
2nd hole	Centre	Category I
3rd hole	Rear	Optional attachments

-Steer the catch hooks (5) below the attaching pin of the implement.

-Raise the front lift until the quick attach (4) closes and engages.

90 145 052