Holder C 9.72 Installing the Cardan Shafts, Removing Implements, C 9700 ... C 9.88 H, Danger

C 9700 ... C 9.88 H

Operating Instructions

Operating the Implements

Installing the Cardan Shafts

Only use the shafts suited and intended for the implement. The shafts are supplied with the implement. The length of the articulated shaft must adjusted before the first installation. In case of doubt, please contact our customer service. Observe installation instructions for the articulated shaft when installing it.

DANGER

Turn off the engine before the installation. After the installation, fit the protective devices as specified. After the removal, cover the PTO shaft (1) with the protective cap again.

Removing Implements

-Drive the implement to its storage place and lower it with the front lift.

-Stop the engine, but do not turn off the ignition.

-Operate all control levers for the front lift several times in all directions. This relieves the pressure in the hydrau- lic system.

-Slide the outer ring of the hydraulic couplings (1) back and disconnect the hydraulic hoses (2).

-Close the protective caps of the hydraulic couplings (as for item 4).

-Remove the upper link from the pin of the upper link support.

-Pull the quick attaches (3) up to release the implement pins.

-Lower the front lift and back off.

1

1 2 3

4

145 052 93