HP 2410 manual Windows operating systems

Software description

NOTE The product automatically restarts the firmware to activate the update. At the end of the update process, the READY message appears on the control panel.

Remote firmware update by using FTP on a direct network connection

If the product uses a direct network connection, use file transfer protocol (FTP) to update your firmware. Complete the following steps for your operating system.

Windows operating systems

1Take note of the TCP/IP address on the EIO Jetdirect page. The HP Jetdirect page is the second page of the configuration page printout. To print a configuration page, see Determining the current level of firmware.

NOTE Before connecting to the product, make sure that the product is not in Sleep mode. Also make sure that any error messages are cleared from the control-panel display.

2Open a command window on your computer.

3Type ftp <TCP/IP printer ADDRESS>. For example, if the TCP/IP address is 192.168.0.90, type ftp 192.168.0.90.

4Press Enter on the keyboard.

5When prompted for the user name, press Enter.

6When prompted for the password, press Enter.

7Type bin at the command prompt.

8Press Enter. The message 200 Type set to I, Using binary mode to transfer files appears in the command window.

9Type put <FILENAME>, where <FILENAME> is the name of the .RFU file that was downloaded from the Web, including the path. For example, type put C:\LJ\2410FW.RFU and then press Enter.

NOTE If the file name or path includes a space, you must enclose the file name or path in quotation marks. For example, type put "c:\My Documents\LJ\2410fw.rfu" .

The following series of messages appears in the command window:

●200 PORT command successful

●150 Opening BINARY mode data connection

●226 Ready

●226 Processing Job

●226 Transfer complete

After these messages appear, a message containing transfer-speed information appears.

58 2 Software description