| |
|
|
Message | Explanation and action |
|
|
Problem found during | A general problem was found during the Advance calibration |
calibration | routine. |
| Respond to any other messages that appear on the front panel, |
| indicating ink or paper problems, and then retry the Advance |
| calibration routine. |
Problems detected in INK | There is an error with the ink cartridges during the preparation of the |
CARTRIDGES. | ink system. |
Continue process and replace | Press the Enter key and then follow the instructions to replace the |
them. | faulty ink cartridges. |
Press ENTER to continue |
|
|
|
Reload paper | There is an error in the paper, as shown in another message. |
| Use the normal procedure to reload the paper. |
|
|
Replace empty cartridges | You have requested the printer to permit printhead replacement, but |
before replacing printheads | the printer has detected that one or more cartridges are empty. The |
| empty cartridges must be replaced before the printheads are |
| replaced. |
| Press the Enter key and follow the procedure for replacing empty |
| cartridges, described in Ink cartridge replacement. |
|
|
Right edge of roll too far from | The paper is out of the load line |
load line | where it should be loaded. |
Press ENTER to retry | Either: Press the Enter key to restart the loading procedure; |
Press CANCEL to abort | Or: Press the Cancel key to cancel paper loading. |
|
|