| |
|
|
Message | Explanation and action |
|
|
Right edge of sheet too far | During the loading of a sheet of paper, the printer has detected that |
from load line | the paper is too far to the left; it should be aligned close to the blue |
Press ENTER to retry | line painted on the right side of the platen. |
Press CANCEL to abort | Either: Press the Enter key to restart the loading procedure; |
| Or: Press the Cancel key to cancel paper loading. |
|
|
Roll edge not found | During the loading of a roll, the printer cannot detect the side edge |
Please check roll edges are | of the paper. A possible cause is that the paper is transparent |
(clear); only opaque paper types are supported. | |
Press ENTER to retry | Either: Press the Enter key to restart the loading procedure; |
Press CANCEL to abort | Or: Press the Cancel key to cancel paper loading. |
Roll right edge too far from | During the loading of a roll of paper, the printer has detected that the |
load line | paper is too far to the left; it should be aligned with the blue line |
Press ENTER to retry | painted on the right side of the platen. |
Press CANCEL to abort | Either: Press the Enter key to restart the loading procedure; |
| Or: Press the Cancel key to cancel paper loading. |
|
|
Sheet edge not found | During the loading of a sheet, the printer cannot detect the side |
Please check sheet edges are | edge of the paper. A possible cause is that the paper is transparent |
(clear); only opaque paper types are supported. | |
Press ENTER to retry | Either: Press the Enter key to restart the loading procedure; |
Press CANCEL to abort | Or: Press the Cancel key to cancel paper loading. |
Sheet not loaded | The printer is trying to perform a scan of the calibration pattern, but |
Load sheet with printed | no sheet was found. |
pattern | Load the sheet that was printed by the Create pattern part of the |
| calibration routine. |