HP 7750 manual Setting Security Privileges

Chapter 5 Operating the Cisco ICS 7750

Setting Security Privileges

page 5-27, and hostname is the host name of the card. For example, an SSP configuration file could be named Backup1_Switch, and an MRP300 configuration file could be named Backup1_R00ffff900073.

Step 7 Repeat Step 6 for the SSP and for every Flash-based MRP or ASI card (MRP300, MRP3-8FXS, MRP3-16FXS, or MRP3-8FXOM1) in the chassis.

Step 8 If you have configured VLAN functionality on the Cisco ICS 7750, you may also back up the file vlan.dat from the SSP Flash memory. This file stores VLAN configuration information.

The procedure for backing up the vlan.dat file is the same as the procedure that is used for copying a Flash file to a network server. To copy the vlan.dat file to a TFTP network server, use the following command in EXEC mode from the command prompt on the SSP:

Switch#copy flash:vlan.dat tftp://<ip address of server>/<dir>/<filename>

where <ip address of server> is the IP address of the TFTP server, <dir> is the directory name on the TFTP server, and <filename> is the filename to write on the TFTP server.

Setting Security Privileges

To ensure that only persons with proper authorization have access to sensitive information, you can designate system passwords during initial configuration of ICS System Manager.

Note For additional information, refer to the ICS System Manager Online Help.

	Cisco ICS 7750 Installation and Configuration Guide
5-30	78-14165-03