HP CQ41-211TX, CQ41-205TX, CQ41-204TX, CQ41-207TX, CQ41-224TX Removal and replacement procedures

Removal and replacement procedures

6.Lift the right side 1 of the system board until it rests at an angle 2.

7.Remove the system board by sliding it to the right at an angle 3 until the connectors on the left side of the system board disengage from the base enclosure.

8.To replace the RJ-11 connector and cable, remove the RJ-11 connector 1 from the clip built into the base enclosure.

9.Remove the cable 2 from the routing channel built into the base enclosure. The RJ-II connector and cable are available using spare part number 494981-001.

Reverse this procedure to install the system board.

Maintenance and Service Guide 4–51