Removal and replacement procedures
4.Remove the two Phillips PM2.0×4.0 screws 1 that secure the hard drive to the computer.
5.Use the Mylar tab 2 on the hard drive to slide the hard drive 3 to the left.
6.Remove the hard drive 4 from the hard drive bay.
7.If it is necessary to replace the hard drive bracket
a.Remove the two Phillips PM3.0×3.0 screws 1 from each side of the hard drive.
b.Lift the bracket 2 straight up to remove it from the hard drive.
Reverse this procedure to reassemble and install the hard drive.
Maintenance and Service Guide |
