HP D3K72UT D3K72UT#ABA manual Test under Storage DPS Self-test, Options Sata Emulation to IDE

Table C-1Numeric Codes and Text Messages (continued)

Control panel message	Description	Recommended action
1720-SMART Hard Drive Detects Imminent	Hard drive is about to fail. (Some hard	1.	Determine if hard drive is giving correct
Failure	drives have a hard drive firmware patch that		error message. Enter Computer Setup
	will fix an erroneous error message.)		and run the Drive Protection System
			test under Storage > DPS Self-test.
		2.	Apply hard drive firmware patch
			if applicable. (Available at
			http://www.hp.com/support.)
		3.	Back up contents and replace hard
			drive.
1796-SATA Cabling Error	One or more SATA devices are improperly	Ensure SATA connectors are used in
	attached. For optimal performance, the	ascending order. For one device, use SATA
	SATA 0 and SATA 1 connectors must be	0.	For two devices, use SATA 0 and SATA
	used before SATA 2 and SATA 3.	1.	For three devices, use SATA 0, SATA 1,
		and SATA 2.
1797-SATA Drivelock is not supported in	Drivelock is enabled on one or more SATA	Either remove the Drivelocked SATA device
RAID mode.	hard drives, and they cannot be accessed	or disable the Drivelock feature. To disable
	while the system is configured for RAID	the Drivelock feature, enter Computer
	mode.	Setup, change Storage > Storage
		Options > SATA Emulation to IDE, and
		select File > Save Changes and Exit.
		Reenter Computer Setup and select
		Security > Drivelock Security. For each
		listed Drivelock-capable SATA device,
		ensure Drivelock is Disabled. Lastly,
		change Storage > Storage Options >
		SATA Emulation back to RAID and select
		File > Save Changes and Exit.
1801-Microcode Patch Error	Processor is not supported by ROM BIOS.	1.	Upgrade BIOS to proper version.
		2.	Change the processor.

2200-PMM Allocation Error during MEBx Download

Memory error during POST execution of the Management Engine (ME) BIOS Extensions option ROM.

1.Reboot the computer.

2.Unplug the power cord, re-seat the memory modules, and reboot the computer.

3.If the memory configuration was recently changed, unplug the computer, restore the original memory configuration, and reboot the computer.

4.If the error persists, replace the system board.

POST Numeric Codes and Text Messages 133