HP D3K72UT D3K72UT#ABA manual Service Considerations, Cleaning the Mouse, Power Supply Fan, Screws

Cleaning the Mouse

Before cleaning the mouse, ensure that the power to the computer is turned off.

●Clean the mouse ball by first removing the retaining plate and the ball from the housing. Pull out any debris from the ball socket and wipe the ball with a clean, dry cloth before reassembly.

●To clean the mouse body, follow the procedures in Cleaning the Computer Case on page 39.

Service Considerations

Listed below are some of the considerations that you should keep in mind during the disassembly and assembly of the computer.

Power Supply Fan

The power supply fan is a variable-speed fan based on the temperature in the power supply.

CAUTION: The cooling fan is always on when the computer is in the “On” mode. The cooling fan is off when the computer is in “Standby,” “Suspend,” or “Off” modes.

You must disconnect the power cord from the power source before opening the computer to prevent system board or component damage.

Tools and Software Requirements

To service the computer, you need the following:

●Torx T-15 screwdriver (HP screwdriver with bits, PN 161946-001)

●Torx T-15 screwdriver with small diameter shank (for certain front bezel removal)

●Flat-bladed screwdriver (may sometimes be used in place of the Torx screwdriver)

●Phillips #2 screwdriver

●Diagnostics software

●HP tamper-resistant T-15 wrench (Smart Cover FailSafe Key, PN 166527-001) or HP tamper- resistant bits (Smart Cover FailSafe Key, PN 166527-002)

Screws

The screws used in the computer are not interchangeable. They may have standard or metric threads and may be of different lengths. If an incorrect screw is used during the reassembly process, it can damage the unit. HP strongly recommends that all screws removed during disassembly be kept with the part that was removed, then returned to their proper locations.

CAUTION: Metric screws have a black finish. U.S. screws have a silver finish and are used on hard drives only.

CAUTION: As each subassembly is removed from the computer, it should be placed away from the work area to prevent damage.

Service Considerations 41