HP recommends using cable tie wraps to secure the base station to an available support bracket.
2.Connect the data transfer cable from the HP Plenum Rated Sensor Array to the base station.
3.After all hardware is installed, power up the components ("Power up procedure" on page 70).
Installation is complete.
Single CRAH installation diagram
Callout | Component | Description |
|
|
|
1 | CRAH return air stream | The return air side of the CRAH |
2 | CRAH supply air stream | The supply air side of the CRAH |
3 | Base station | The base station is mounted on the supply air side of the CRAH. |
4 | Supply side of plenum array | The |
|
| and humidity. |
5 | Return side of plenum array | The |
HP Environmental Base Station installed on a CRAH/CRAC 27