b.Select Port 1 to change the serial port settings.

c.On the Mode menu, select RS-485.

NOTE: The baud rate you set on the ION Energy Meter Modbus ID ("Programming the Modbus ID" on page 59) must match the baud rate you set in the Modbus Base Station configuration ("Configuring the Modbus Base Station" on page 61).

d.On the Baud menu, select the appropriate baud rate. If multiple meters are connected in a daisy chain series, each meter must use the same baud rate.

6.Configure the Ethernet Device.

(Optional) Sensor Base Stations 66