INITiate

 

The INITiate subsystem selects continuous scanning cycles and starts the

 

scanning cycle.

Subsystem Syntax

INITiate

 

:CONTinuous ON OFF 1 0

 

:CONTinuous?

 

[:IMMediate]

:CONTinuous

INITiate:CONTinuous ON OFF 1 0 enables or disables continuous

 

scanning cycles for the switchbox.

Parameters

Parameter Name

Parameter Type

Range of Values

 

 

 

ON OFF 1 0

boolean

ON OFF 1 0

 

 

 

Comments Continuous Scanning Operation: Continuous scanning is enabled with the INITiate:CONTinuous ON or INITiate:CONTinuous 1 command. Sending the INITiate[:IMMediate] command closes the first channel in the channel list.

Each trigger from a trigger source selected by the TRIGger:SOURce command advances the scan through the channel list. A trigger at the end of the channel list closes the first channel in the channel list and the scan cycle repeats.

Non-Continuous Scanning Operation: This is enabled with the

INITiate:CONTinuous OFF or INIT:CONT 0 command. Sending the

INIT:IMM command closes the first channel in the channel list.

Each trigger from a trigger source selected by the TRIGger:SOURce command advances the scan through the channel list. At the end of the scanning cycle, all channels in the channel list are closed.

Stopping Continuous Scans: See the ABORt command.

Related Commands: ABORt, ARM:COUNt, TRIGger

*RST Condition: INITiate:CONTinuous OFF

Example Enabling Continuous Scans

This example enables continuous scanning of channels 00 through 03 of a single-module switchbox. Since TRIGger:SOURce IMMediate (default) is set, use an interface clear command (such as CLEAR) to stop the scan.

INIT:CONT ON

! Enable continuous scanning

SCAN (@100:103)

! Define channel list

INIT

! Start scan cycle, close channel 00

Chapter 5

HP E1366A/E1367A RF Multiplexers Command Reference 45

Page 45
Image 45
HP E1367A, E1366A INITiate, ∙ Non-Continuous Scanning Operation This is enabled with, Example Enabling Continuous Scans