Mentor v8.6_4 manual Command Dictionary Delete Nofaults

Command Dictionary Delete Nofaults

∙-Instance

An optional switch that specifies interpretation of the pathname argument as an instance pathname.

∙-Module

An optional switch specifies interpretation of the pathname argument as a module pathname. All instances of these modules are affected.

∙-Stuck_at 01 0 1

An optional switch and literal pair that specifies the stuck-at values which you want to delete. The valid stuck-at literals are as follows:

01 — A literal that deletes both the “stuck-at-0” and “stuck-at-1” nofault settings. This is the default.

0 — A literal that deletes the “stuck-at-0” nofault settings.

1 — A literal that deletes the “stuck-at-1” nofault settings.

∙-Class User System Full

An optional switch and literal pair that specifies the source (or class) of the nofault settings which you want to delete. The valid literals are as follows:

User — A literal that deletes the user-entered nofault settings. This is the default.

System — A literal that deletes netlist-based nofault settings.

Full — A literal that deletes all the nofault settings in the user and system classes.

Examples

The following example deletes an extra nofault setting from the instance i_1007 and then adds all faults to the circuit, thereby allowing the tool to add faults to the pin names of the i_1007 instance:

add nofaults i_1006 i_1007 i_1008 -instance delete nofaults i_1007 -instance

set system mode atpg add faults -all

FastScan and FlexTest Reference Manual, V8.6_4 2-187