Mentor v8.6_4 manual Set Iddq Strobe, ∙ -Label

Set Iddq Strobe Command Dictionary

Set Iddq Strobe

Tools Supported: FastScan and FlexTest

Scope: All modes

Prerequisites: You must be fault simulating, or selecting from, an external pattern source.

Usage

SET IDdq Strobe -Label -All

Description

Specifies on which patterns (cycles) the tool will simulate IDDQ measurements.

The Set Iddq Strobe command affects stand-alone fault simulation as well as pattern selection when you use the Select IDDQ Patterns command. Set IDDQ Strobe determines whether the tool simulates only existing IDDQ measure statements within an external pattern source or if it should assume that every pattern (cycle) in the set has an IDDQ measure statement. The command performs slightly differently depending on whether you are using FastScan or FlexTest. In either case you can use the Report Environment command to list the current setting. The following paragraphs describe how the Set Iddq Strobe command operates for each tool.

FastScan Specifics

The Set Iddq Strobe command specifies which fault grading patterns will perform IDDQ measures during simulation.

FlexTest Specifics

The Set Iddq Strobe command specifies which test cycles will perform IDDQ measures during simulation.

Arguments

∙-Label

This is the default behavior upon invocation of either tool.

2-506 FastScan and FlexTest Reference Manual, V8.6_4