Add Output Masks | Command Dictionary |
|
|
Add Output Masks
Tools Supported: FastScan and FlexTest
Scope: Setup mode
Usage
ADD OUtput Masks primary_output...
Description
Ignores any fault effects that propagate to the primary output pins you name.
The tool uses primary output pins as the observe points during the fault detection process. When you mask a primary output pin, you inform the tool to mark that pin as an invalid observation point during the fault detection process. This command allows you the ability to flag primary output pins that do not have strobe capability. The tool classifies the faults whose effects only propagate to that observation point as Atpg_Untestable (AU).
Arguments
∙primary_output
A required repeatable string that specifies the name of the primary output pin you want to mask.
Examples
The following example specifies the primary output pins that will not have the strobe capability on the hardware tester:
add output masks qb1 qb2 qb3
Related Commands
Delete Output Masks | Report Output Masks |
FastScan and FlexTest Reference Manual, V8.6_4 |
