Mentor v8.6_4 manual Command Dictionary Write Faults

Command Dictionary Write Faults

∙fault code - A code name indicating the lowest level fault class assigned to the fault.

∙fault site - The pin pathname of the fault site.

You can use the -Hierarchy option to write a hierarchical summary of the selected faults. The summary identifies the number of faults in each level of hierarchy whose level does not exceed the specified level number. You can further specify the hierarchical summary by using the -Min_count option which specifies the minimum number of faults that must be in a hierarchical level before writing.

You may select to display either collapsed or uncollapsed faults by using the Set Fault Mode command.

Arguments

∙filename

A required string that specifies the name of the file where FastScan is to write the fault information.

∙-Replace

An optional switch that replaces the contents of the file if the filename already exists.

∙-Classclass_type

An optional switch and literal pair that specifies the class of faults that you want to write. The class_type argument can be either a fault class code or a fault class name. If you do not specify a class_type, the default is to write all fault classes.

Table 2-2 on page 2-299lists the valid fault class codes and their associated fault class names; use either the code or the name when specifying the class_type argument.

∙-Stuck_at 01 0 1

An optional switch and literal pair that specifies the stuck-at faults that you want to write. The stuck-at literal choices are as follows:

01 — A literal that writes both the “stuck-at-0” and “stuck-at-1” faults. This is the default.

FastScan and FlexTest Reference Manual, V8.6_4 2-639