Mentor v8.6_4 manual Set Gate Report

Command Dictionary Set Gate Report

Set Gate Report

Tools Supported: DFTInsight, FastScan, and FlexTest

Scope: All modes

Usage

For FastScan

SET GAte REport {Normal Trace Error_pattern Fault_status Bist_data TIe_value Constrain_value Seq_depth_data Clock_cone pin_name {Drc_pattern procedure_name [-All time]} {Parallel_pattern pattern_number} {CApture_pattern [n All]}}

For FlexTest

SET GAte REport {Normal Race Trace Error_pattern TIe_value Constrain_value Clock_cone pin_name Analysis [Control Observe] {Drc_pattern procedure_name [-All time]} Parallel_pattern pattern_number REcord {cycle_number -All} SImulation CONTrol}

DFTInsight Menu Path:

Setup > Reporting Detail

Description

Specifies the additional display information for the Report Gates command.

The Set Gate Report command controls the type of additional information that the Report Gates command displays. Each Set Gate Report option causes the Report Gates command to provide different details regarding the gates on which it reports. This command also controls the information displayed for each instance in the DFTInsight Schematic View area.

When you exit the Setup system mode, the trace and any rules-checking error pattern results will not be available with the usage of this command.

For information on the format output by the different options in this command, refer to the Report Gates reference page.

FastScan and FlexTest Reference Manual, V8.6_4 2-491