Mentor v8.6_4 manual Command Dictionary Add Faults

Command Dictionary Add Faults

∙-Stuck_at 01 0 1

An optional switch and literal pair that specifies which stuck-at faults to add to the fault list. The stuck-at values are as follows:

01 — A literal specifying that the tool add both the “stuck-at-0” and “stuck- at-1” faults. This is the default.

0 — A literal specifying that the tool add only the “stuck-at-0” faults. 1 — A literal specifying that the tool add only the “stuck-at-1” faults.

∙-Both -Rise -Fall (FastScan only)

An optional switch that specifies which faults to add for each path already added via the Add Paths command. These switches are used for path delay faults only.

-Both - An optional switch the specifies to add both the slow to rise and slow to fall faults. This is the default.

-Rise - An optional switch that specifies to add only the slow to rise faults.

-Fall - An optional switch that specifies to add only the slow to fall faults.

Examples

The following example adds all faults to the circuit so that you can run the ATPG process:

set system mode atpg add faults -all

run

Related Commands
Delete Faults	Set Fault Mode
Load Faults	Set Fault Type
Report Faults	Write Faults
Report Testability Data

FastScan and FlexTest Reference Manual, V8.6_4 2-67