Setup Pin Strobes | Command Dictionary |
|
|
Setup Pin Strobes
Tools Supported: FlexTest
Scope: Setup mode
Usage
SETup PIn Strobes integer
Description
Changes the default strobe time for primary outputs without specified strobe times.
The Setup Pin Strobes command changes the default strobe time of each test cycle for all primary outputs not specified with the Add Pin Strobes command. For scan circuits, FlexTest gives the last timeframe of each test cycle as the strobe time. For nonscan circuits, FlexTest gives time 1 of each test cycle as the strobe time.
Arguments
∙integer
An integer which specifies the strobe time of each test cycle for all primary outputs without a specified strobe time. This number should not be greater than the period set with the Set Test Cycle command.
∙
Specifies the number of cycles for the period of each strobe. The default is 1.
Examples
The following example sets the strobe time to 2 for two primary outputs and changes the default strobe time to 3 for the rest:
set test cycle 4
add pin strobes 2 outdata1 outdata3 setup pin strobes 3
Related Commands |
|
Add Pin Strobes | Report Pin Strobes |
Delete Pin Strobes |
|
FastScan and FlexTest Reference Manual, V8.6_4 |
