Set Gate Report

Command Dictionary

 

 

Arguments

Normal

A literal that specifies for the Report Gates command to display only its standard information. This is the default mode upon invocation of the tool.

Race (FlexTest Only)

A literal that specifies for the Report Gates command to display the simulated values of the gates for race conditions. To make the race conditions reportable, you must first use the Analyze Race command to check for race conditions between clock and data signals.

The Report Gates command displays any one of five possible simulated values. These values are: S, N, 0, 1, or Z, where S (same) indicates an unknown value that remains unchanged since the previous timeframe, and where N (new) indicates an unknown value that changes after the previous timeframe.

Trace

A literal that specifies for the Report Gates command to display the simulated values of the gates during the scan chain tracing. The format of these values depends on the contents of the shift procedure. If the shift procedure contains additional frames, the additional frames will also be displayed in the gate report data. The trace data relates to the simulation performed during the scan chain tracing. Use the Trace option to determine why a scan chain was not properly sensitized during the shift procedure.

See the Examples section of this command for an example of the information displayed.

Error_pattern

A literal that specifies for the Report Gates command to display the simulated value of the gates and its inputs for the pattern at which an audit error occurred.

Fault_status (FastScan Only)

A literal that specifies for fault detection status of both SA-0 and SA-1 of all gates to be preserved. Subsequent commands which cause the gate to be displayed, will annotate the pins with fault status data. Therefore, in the case that a schematic is currently displayed in DFTInsight and the user changes the gate report data (by issuing the Set Gate Report command), all fault sites will be annotated by the fault detection status.

2-492

FastScan and FlexTest Reference Manual, V8.6_4

Page 520
Image 520
Mentor v8.6_4 manual ∙ Normal, ∙ Race FlexTest Only, ∙ Trace, ∙ Errorpattern, ∙ Faultstatus FastScan Only