Mentor v8.6_4 manual ∙ -TIEXFastScan Only, ∙ -TLatchFastScan Only, ∙ -INIT0FastScan Only

Report Nonscan Cells Command Dictionary

∙-TIE0

An optional switch that displays the non-scan cells which are always 0 after each loading and before the next unloading.

Non-scan cells that the tool models as TIE0 indicate that the pin constraints hold the cell’s value during non-scan operation.

∙-TIE1

An optional switch that displays the non-scan cells which are always 1 after each loading and before the next unloading.

Non-scan cells that the tool models as TIE1 indicate that the pin constraints hold the cell’s value during non-scan operation.

∙-TIEX(FastScan Only)

An optional switch that displays the non-scan cells which are always unknown

(X) after each loading and before the next unloading.

∙-TLatch(FastScan Only)

An optional switch that displays the non-scan cells which FastScan models as transparent latches.

∙-Clock_sequential (FastScan Only)

An optional switch that displays all clock_sequential cells that are valid when the sequential depth is set to non-zero.

∙-INIT0(FastScan Only)

An optional switch that displays a list of cells which DRC has identified as being initialized to 0 by scan load but has failed to prove that it is tied to 0.

Non-scan cells that the tool models as INIT0 indicate one of the following:

oThe test procedure can set the memory element to 0 after scan loading.

oThe non-off clock is a reset.

∙-INIT1(FastScan Only)

An optional switch that displays a list of cells which DRC has identified as being initialized to 1 by scan load but has failed to prove that it is tied to 1.

2-342 FastScan and FlexTest Reference Manual, V8.6_4