Command Dictionary

Add Pin Strobes

 

 

Add Pin Strobes

Tools Supported: FlexTest

Scope: Setup mode

Usage

ADD PIn Strobes strobe_time primary_output_pin... [-Period integer]

Description

Adds strobe time to the primary outputs.

The Add Pin Strobes command adds a strobe time for each test cycle of the specified primary output pins. Any primary outputs without specified strobe times use the default strobe time. For nonscan circuits, the default strobe time is the last timeframe of each test cycle. For scan circuits, FlexTest designates time 1 of each test cycle as the default strobe time for every primary output. You can change the default time frame for non-scan operations by using the -Period option.

Arguments

strobe_time

A required integer that specifies the strobe time for each test cycle. This number should not be greater than the period set with the Set Test Cycle command.

primary_output_pin

A required repeatable string that specifies a list of primary output pins.

-Period integer

Specifies the number of cycles for the period of each strobe. The default is 1. This option is only available for non-scan operations.

Examples

The following example adds time 1 as the strobe time of primary output pin outdata1.

set test cycle 3

add pin strobes 1 outdata1

FastScan and FlexTest Reference Manual, V8.6_4

2-101

Page 129
Image 129
Mentor v8.6_4 manual Add Pin Strobes, ∙ strobetime, ∙ primaryoutputpin