Command Dictionary | Report Initial States |
|
|
Report Initial States
Tools Supported: FlexTest
Scope: All modes
Usage
REPort INitial States
Description
Displays the initial state settings of the specified design instances.
The Report Initial States command displays different information regarding the initialization settings depending on the mode from which you issue the command. If FlexTest is in the Setup mode, the command displays the initialization settings that you created by using the Add Initial States command. If FlexTest is in any other mode, the command displays all the initial state settings (including those in any test_setup procedures).
Arguments
∙
An optional switch that displays the initialization settings for all design hierarchical instances. This is the default.
∙instance_name
An optional repeatable string that specifies the names of the design hierarchical instances for which you want to display the initialization settings.
Examples
The following example assumes you are not in Setup mode and displays all the current initial settings:
add initial states 0 /amm/g30/ff0 set system mode atpg
report initial states
0 /amm/g30/ff0
FastScan and FlexTest Reference Manual, V8.6_4 |